Product manual

Page 8 For technical questions, please call 1-800-444-3353. SKU 37025
FUNCTIONAL DESCRIPTION
Specications
Compressor
Requirements
1 HP or larger
compressor
Air Inlet 1/4” NPT
Average Air
Consumption
2 CFM @ 50 PSI
Maximum Air Pressure 120 PSI
Hopper Capacity 50 lbs.
Abrasive Supply Hose 15 ft.
Accessories One 3mm Hex Key
Components and Controls
Discharge
Gun (6A)
Trigger
Abrasive
Supply
Connection
Air Inlet
(5A)
Abrasive
Supply
Hose (4A)
Hopper (1A)
Lock Nut (3A)
Bleeder
Valve
(2A)
Figure 1
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
This air tool may be shipped with a •
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.