Product manual

Page 11For technical questions, please call 1-800-444-3353.SKU 37025
GENERAL OPERATING
INSTRUCTIONS
WARNING: Wear ANSI-approved safety
goggles, gloves, a NIOSH-approved
protective face mask, and Hard Hat
when using the Spot Blaster.
Set the compressor’s pressure 1.
regulator to 50-120 PSI. Do not set
the compressor’s outlet regulator
over 120 PSI.
Connect air supply to the air inlet 2.
of the gun. If leaking is detected,
disconnect the air hose and repair
before use.
Fill the Hopper (1A) with an 3.
appropriate abrasive such as steel
grit or glass bead abrasive, checking
to ensure that the abrasives are dry
and clean.
Place the material to be sandblasted 4.
in an area suitable for this kind of
work.
CAUTION: The blasting medium will
accumulate and cover items near
the blasting area, possibly damaging
nishes or contaminating moving
parts. Place the compressor in
another room to prevent it from being
damaged.
Holding the Discharge Gun so that it 5.
is pointing away from you, turn on the
air compressor.
Squeeze the trigger on the Discharge 6.
Gun (6A) to begin operation. Release
it to stop.
Use even passes of the Discharge
Gun to remove rust, paint, etc. Do not
keep the Gun point in one location
continously to prevent damage to the
item.
Note: Use caution when sandblasting
unfamiliar material. Test the tool on
a small area before proceeding. This
will ensure you will not damage or pit
the material you wish to sandblast.
WARNING: Do not point the gun towards
your face, any part of yourself, or at
any other person or animal.
If the tool requires more force to 7.
accomplish the task, verify that the
tool receives sufcient, unobstructed
airow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool’s maximum
air pressure rating.
If the tool still does not have sufcient
force at maximum pressure and
airow, then a larger tool may be
required.
To prevent accidents, release the 8.
Trigger, detach the air supply, safely
discharge any residual air pressure
in the airline, and release the trigger
after use. Clean external surfaces of
the tool with a clean, dry cloth. Then
store the tool indoors out of children’s
reach.