Product manual

Page 12 For technical questions, please call 1-888-866-5797. Item 60693
Mode $06 – Non-Continuously Monitored Systems test
results. There are typically a minimum value, a maximum value,
and a current value for each non-continuous monitor. This data is
optional, and it is defined by a given vehicle maker if it's used.
Mode $07 – Request for DTCs (pending) from Continuously
Monitored Systems after a single driving cycle has
been performed to determine if repair has fixed a
problem. This is used by service technicians to verify repair
was performed properly and after clearing DTCs.
Mode $08 – This special Control Mode requests control of
the on-board system, test, or component bi-directionally
(where applicable). This mode is manufacturer specific.
Mode $09 – Reports vehicle information. This
information includes vehicle VIN number and calibration
information stored in the vehicle's ECU.
Mode $0A – Request Emission-Related Diagnostic Trouble
Codes with Permanent Status. This mode is required for all
emissions-related DTCs. The presence of permanent DTCs at
an inspection without the MIL illuminated is an indication that a
proper repair was not verified by the on-board monitoring system.