Product manual

Page 5For technical questions, please call 1-888-866-5797.Item 60723
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note: Unless stated otherwise, all connections are
made using Bolts, Washers and Nuts (B). Finger tighten
all connections until assembly is done. Assemble
the Workbench on a flat, level, hard surface.
1. Attach Side Beams (4) to Front (1)
and Back Posts (2).
2. Attach Rubber Feet (3) to the bottom of each post.
1
2
4
3
3
1
2
3
3
4
Figure A
3. Attach Bottom Beams (5) to Front and Back Posts.
5
5
Figure B
4. Attach Side Beam (4) and Side Beam with Power
Strip Opening (4A) to the top 2 holes on Front
Posts and the middle 2 holes on Back Posts.
Note: Side Beam with Power Strip Opening can
be attached to either the right or left side.
5. Attach Power Strip (22) to Side Beam with Power
Strip Opening using U Brackets (F) and Screws (E).
4
4A
22
F
F
E
Figure C
6. Attach Top Beams (6) to the top 2 holes on
Front Posts and the middle 2 holes on Back Posts.
Note: Make sure the Front Top Beam carries
the Warning Label and is right-side up.
6
6
Warning
Label
1
Figure D