Product manual

Page 4 For technical questions, please call 1-800-444-3353. Item 60307
4. To do so, unscrew and remove
the Forcing Screw, Steel Ball,
and O-Ring from the C-Frame.
5. Make sure Steel Ball and O-Ring
remain inside the Forcing Screw. Then
insert Plug Bolt into Forcing Screw.
6. Screw threaded end of Forcing Screw,
with its Steel Ball, O-Ring, and
attached Plug Bolt back into
threaded end of C‑Frame toward
unthreaded hole of C‑Frame.
Removing a Ball Joint
1. NOTE: The following instructions apply
to most GM
®
, Ford
®
, and Dodge
®
2 and 4 wheel drive pickups, vans, and
SUV’s through 1997 (see charts on
pages 6 through 9). The instructions
are intended to illustrate the process in
general terms, and NOT to be
specic to any one make/model vehicle.
A combination of Receiving Tubes
(parts 1-6 and 10-11), Receiving
Cups (parts 7 and 12), and
Installing Tubes (parts 8‑9), will be
necessary for different vehicles.
2. Remove all attaching
hardware from ball joint.
3. Mount Remover/Installer (13) on
Forcing Screw assembly so that
larger diameter portion of Remover/
Installer faces threaded hole of
C‑Frame, and smaller diameter
portion faces unthreaded side of
ball joint. See Figure B below.)
4. Mount proper size Receiver Tube
over threaded side of ball joint.
5. Align mounted Remover/Installer,
ball joint, and Receiver Tube to
allow removal of ball joint.
6. Using a wrench, turn Forcing Screw
assembly clockwise to remove ball joint.
Figure B
C‑Frame
(Part of Item
4065)
Forcing
Screw
(not included)
Plug Bolt (14)
Remover /
Installer (13)
Receiver Tube
(1‑6, 10‑11)