Product manual

Page 2 For technical questions, please call 1-888-866-5797. Item 99701
Specifications
Maximum Weight Capacity 700 lb
Adjustable Width 10-1/2" min. to 14" max.
IMPORTANT SAFETY INFORMATION
Assembly Precautions
1. Assemble only according to these instructions.
Improper assembly can create hazards.
2. Wear ANSI-approved safety goggles and
heavy-duty work gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under the
influence of alcohol, drugs or medication.
6. Weight capacity and other product capabilities apply
to properly and completely assembled product only.
Use Precautions
1. This product is not a toy. Do not allow
children to play with or near this item.
2. Use as intended only. Not for any aircraft purpose.
3. Inspect before every use; do not use
if parts are loose or damaged.
4. The floor must be firm, level and in good repair.
The floor must be strong enough to support
the weight of the tool and the vehicle.
5. Do not exceed listed weight capacity.
Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing product failure.
6. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. Loosely assemble the Bracket Covers (3) to the
ends of each Support Arm (2) using the Bolts (11).
2. Insert the Square rods of the Left and Right
Support Brackets (4, 5) into the Bracket
Covers as shown in the assembly diagram.
3. Adjust the Left and Right Support Brackets to
match the width of your motorcycle axle.
4. Tighten the Support Brackets firmly in
place by tightening the Bolts (11).