Product manual

Page 8 For technical questions, please call 1-888-866-5797. Item 61959
Set Up Instructions (continued)
Manual Code Search with the Remote
1. Manually turn on the device to be
programmed into the Remote.
2. Aim the Remote at the device and
press and hold the corresponding
Device Select Control button until
the LED Indicator Light turns on and
stays solid red. Release the button.
3. Press the “CH+” button on the Remote
and release. Repeat this action
slowly and continuously to search.
It may take up to 300 repetitions to
reach the correct code since the unit
is searching through all the codes.
4. When the device shuts off,
immediately press ENTER to save
the code. The LED will shut off. If
the device shuts off and “CH+” is
pressed again accidentally, press
“CH-” the same number of times
to return to the correct code. Then
press ENTER to save the code.
5. Press the ON/OFF button on
the Remote. If the device turns
on, this may be the correct
code. Test other buttons on the
Remote to verify functionality.
6. If the device does not turn on, or if
all of the other buttons do not work
correctly, return to step 2 to repeat
this search option, or use one of
the alternate search methods.
Auto Code Search
1. Manually turn on the device to be
programmed into the Remote.
2. Aim the Remote at the device and
press and hold the corresponding
Device Select Control button until
the LED Indicator Light turns on and
stays solid red. Release the button.
3. Press and release the ON/OFF button
on the Remote. The LED will flash
intermittently as the Remote searches
for the correct code. When the device
shuts off, immediately press ENTER to
save the code. The LED will shut off.
4. Press the ON/OFF button on
the Remote. If the device turns
on, this may be the correct
code. Test other buttons on the
Remote to verify functionality.
5. If the device does not turn on, or
if all of the other buttons do not
work correctly, return to step 2
to repeat this search option.
6. The Remote will perform a complete
search cycle. If the LED flashes twice
and then shuts off, the Remote has
searched all the codes without finding
the correct code and quit the search
mode. No code will be saved.