Product manual

Page 3For technical questions, please call 1-800-444-3353.SKU 69619
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of
this document including all
text under subheadings therein
before set up or use of
this product.
1. NOTE: Applications and operating
procedures can differ depending
on the make and model of
vehicle. A generalized description
of procedures is as follows:
2. To replace inner tie rod, remove
the wheel from the vehicle.
3. Loosen jam nut on outer tie
rod. Then remove outer tie rod
from the steering knuckle.
4. Turn outer tie rod counterclockwise,
making sure to count turns so that outer
is installed at same distance as it was.
5. Remove tie rod boot.
6. Slide inner tie rod tool over inner
tie rod and wrench it off.
7. Use Main Socket (1) to install new
inner tie rod. NOTE: If new inner
tie rod has small allen bolt, tighten
bolt after tightening inner tie rod
to rack. Also, it is recommended
to apply small amount of a thread
locking product (sold separately)
on inner tie rod to rack threads.
8. Re-install boot. If necessary, use hose
clamps to secure both ends of boot.
9. Thread outer tie rod on specic
number of turns. Install outer tie rod
back into steering knuckle. NOTE:
Have an alignment shop set the
toe (and check the other angles).
Maintenance and Servicing
1. Before each use, inspect general
condition of tool. Check for
misalignment or binding of moving
parts, cracked or broken parts,
and any other condition that may
affect its safe operation. Do not
use damaged equipment.
2. After use, clean external surfaces.
Then dry and lubricate all moving
parts. Do not use solvents.
3. When storing, keep Inner Tie Rod and
its accessories in its Carrying Case
and store in a clean, dry, safe location.
4. CAUTION! All maintenance, service,
and repairs not mentioned in this
manual must only be performed by a
qualied service technician.
Record Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
PLEASE READ THE FOLLOWING CAREFULLY
NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT, OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY
PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR
HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR
ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.