Product manual

Item 66150 For technical questions, please call 1-888-866-5797. Page 3
PARTS LIST & ASSEMBLY DIAGRAM
Part # Description Qty. Part # Description Qty.
1 Hydraulic Cylinder 1 10 Handle Pin 2
2 Piston 1 11 Circlip 4
3 O-Ring (30 x 3.1) 2 12 Injection Piston 1
4 Ring (30 x 2) 1 13 Pump Handle 1
5 Piston Spring 1 14 Fixed Handle 1
6 Magnet 2 15 Faucet 1
7 Crimping Dies 18 16 Fount 1
8 Pincer Head 1 17 Hydraulic Oil Return Valve 1
9 Plank 1 18 Carrying Case 1
INSPECTION & CLEANING
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT INJURY
FROM TOOL FAILURE:
Do not use damaged equipment. If
abnormal noise or vibration occurs,
have the problem corrected before
further use.
1. BEFORE EACH USE: Inspect the
general condition of the Hydraulic Wire
Crimping Tool. Check for misalignment
or binding of moving parts, cracked or
broken parts, and any other condition
that may affect its safe operation.
2. TO REPLACE THE O-RINGS (3)
AND RING (4): Only a qualified
service technician should attempt to
replace the O-Rings and/or Ring.
3. TO CLEAN THE HYDRAULIC
WIRE CRIMPING TOOL: Use a
clean cloth with a mild detergent.
Then dry. Do not use solvents.
CAUTION
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only,
and are not available individually as replacement parts.