Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 61838
Charging the Battery
1. Plug the Power Supply into the DC
Power Input, then plug other end
into a grounded 120V outlet.
2. The red Charging Indicator will
come on and will turn green
when charging is finished.
3. DO NOT charge longer than
recommended.
(See “Specifications” on page 4.)
4. When charging is complete, disconnect
Camera from Power Supply, then
unplug Power Supply from outlet.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Camera is OFF and unplugged from its
charger before performing any procedure in this section.
1. Connecting Cable:
a. Carefully push Cable’s key
into Cable Connector’s slot.
b. Turn Cable Connector
counterclockwise until the
Cable and Cable Connector
are securely attached.
2. Disconnecting Cable:
a. Turn Cable Connector clockwise
until the Cable and Cable
Connector are detached.
b. Remove Cable.
Cable
Key
Slot
Cable
Connector
Figure A
3. Micro SD Card
a. Insert the Micro SD Card into the
Memory Card Slot, then push down
on the card until it clicks into place.
Note: When the card is installed, the
SD
icon will appear on the Display Screen.
b. To remove card, push down on the
card until it pops up, then remove.
4. Attaching Accessories:
a. Hold the accessory against
the Imager Head, placing
the Hook in the hole.
b. Match the slot on the Sleeve
to the accessory, then slide the
Sleeve down the Imager Head
until it covers the Hook.
Imager
Head
Accessory
Sleeve
Hook
Figure B
5. Connecting to Computer with
USB to Mini-B Cable:
Plug the Mini-B end into the Mini-B Port,
then plug the USB end into a computer.
6. Connecting to External
Monitor with RCA Cable:
Plug one end into the RCA Video
Out Port, then plug other end into
RCA Video In Port on monitor.