Specifications Hammer Weight 5 lb. Functions Internal or external 3-jaw puller Internal or external 2-jaw puller Puller hook Rear axle puller Dent puller Threaded Puller/Wrench Adapter Important Safety Information 1. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly and use. 2. Inspect before every use; do not use if parts are damaged. 3. Do not use for aircraft purposes; use as intended only. 4.
Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Assembly 1. Slide the plain end of the Slide Hammer (12) onto Spindle (11). Slide Hammer (12) 2. Thread Lock Nut (3) onto threaded end of Spindle (11), hollow side first. It serves as a Hammer Stop for the forward motion of the Slide Hammer (12). Spindle (11) Cross Bar (9) Lock Nut (3) Figure A 3.
External Grip Jaw Operation 1. Use the Bolts and Nuts to attach the Jaws to the 2 or 3 Jaw Puller Adapters (6/10), as needed. Thread the adapter onto the Spindle until non-threaded end of the Spindle exits the Adapter. Note: To grip the work piece externally, claws of the Jaws should be facing inward, as shown in Figure C and Figure D. 2. Clamp the Jaws onto the object to be pulled.
Operation (Dent Pulling) 1. Drill a 1/8" hole into the center of the dent. 2. Place the Screw (13) through the Dent Puller Adapter (7). See Figure E. 3. Thread the Screw into the drilled hole using a #2 Phillips screwdriver. 4. Thread the Spindle into the Dent Puller Adapter. Thread the Lock Nut (3) against the Dent Puller Adapter and hand tighten. 5. Push the Slide Hammer towards the work piece, and then forcefully pull it back towards the cross bar end. Repeat and adjust force as needed.
Maintenance and Servicing TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. Cleaning, Maintenance, and Lubrication 1. BEFORE EACH USE, inspect the 2. AFTER USE, wipe the tool general condition of the tool. Check for: off with a clean cloth. • loose hardware, • misalignment or binding of moving parts, • cracked or broken parts, and • any other condition that may affect its safe operation.
Parts List and Diagram Part 1 2 3 4 5 6 7 Description Qty. Bolt and Nut Set (M8 x 1.25) Rear Axle Puller Lock Nut Jaw Puller Hook 2-Jaw Puller Adapter Dent Puller Adapter Part 3 1 1 3 1 1 1 11 8 9 10 11 12 13 Description 12 3 6 Qty. Bolt Adapter (M12 x 1.75) Handle Cross Bar 3-Jaw Puller Adapter Spindle Slide Hammer Screw 1 1 1 1 1 1 9 1 13 2 7 5 8 Record Serial Number Here: Note: If product has no serial number, record month and year of purchase instead.
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.
