Product manual

Page 5For technical questions, please call 1-888-866-5797.Item 69055
Assembly
TO PREVENT SERIOUS INJURY:
Scaffold components from other
manufacturers must not be used with
this Scaffold. Safety equipment added
to this Scaffold, such as rails, toe
guards, stability strapping, and safety
harnesses, must be installed by a qualified
technician. They must fit together
without being forced, and the Scaffold’s
structural integrity must be maintained.
1.
Figure 1
Swivel Caster (4)
Locking
Pin (5)
Pin
Spring (6)
Mount the Swivel Casters (4) to the bottom of
End the Frame (2) by sliding each Swivel
Caster (4) into a leg and securing it with a
Locking Pin (5). Then snap the Pin Spring (6)
around the end of the Locking Pin (5) to keep
it in place. See Figure 1.
2.
Figure 2
Height
Adjustment
Pin (7)
Locking Pin (5)
& Pin Spring (6)
Side
Rail (1)
Slide a Side Rail (1) onto the End Frame
(2) and secure in place using Height
Adjustment Pin (7) and the Locking Pin (5)
and Pin Spring (6). See Figure 2. MAKE
SURE THE PINS FULLY ENGAGE.
3.
Figure 3
Guard Rail
Holder
Wooden Platform (3)
End Frame (2)
Platform Hold
Down (8)
Flange Pin in
oblong hole
Lay the Wooden Platform (3) over the
Flange Pins that extend up from the
Side Rails (1) and into the oblong holes
cut in the Wooden Platform (3). These
Flange Pins must fit properly. Secure the
Wooden Platform (3) in place with the
Platform Hold Downs (8). See Figure 3.
4. The two Platform Hold Downs (8) must be
in position as seen in Figure 3 at all times
to keep the Wooden Platform secure.