Product manual

Page 3For technical questions, please call 1-888-866-5797.Item 62373
6. Mist Resurfacing Pads with water. Keep
Pads wet during entire sanding process.
7. Attach Drill Mount Plate to
drill (sold separately).
8. Place Pad on headlight and sand at
the highest speed the drill will reach.
Sand for 3-5 minutes, or until all
coatings or damage are removed.
9. Remove Resurfacing Pad before
using Polishing Pad.
10. Remove release paper from Polishing
Pad, and adhere to Drill Mount Plate.
11. Place a small amount of Polishing
Compound on face of Polishing Pad.
12. Polish headlight for 3 minutes,
adding water to pad as needed.
13. Once surface shines, rinse
clean with water.
14. WARNING! Check headlights for proper
operation before driving. If headlights
are damaged, or stain is internal
instead, they will need to be replaced.
Components
Drill Mount Plate
Resurfacing Pads
Polishing Pad
Polishing Compound