Product manual

Page 3For technical questions, please call 1-888-866-5797.Item 61581
Installation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under subheadings therein
before set up or use of this product.
Mounting
1. The mounting location must be able to support
the weight of both the safe and its contents.
2. Remove felt pad from inside of safe.
3. Using the holes in the bottom of the Safe
as a template, lay the Safe in the desired
location and drill all four pilot holes.
4. Once the pilot holes have been drilled, secure
the Safe with the supplied 1-1/2" wood screws.
a. Screw through the holes in the bottom of
the Safe and into the drawer bottom.
b. If the screws included with the Safe are
too long, replace them with the appropriate
length wood screws (not supplied) for
the intended mounting surface.
5. Place the supplied felt pad in the Safe so as to
cover the Safe bottom and mounting screws.
Batteries
1. Remove the cover from the battery
compartment, found on the ceiling of the safe.
2. Insert four AA batteries, taking
note of the proper polarity.
3. Replace the battery cover.
Note: Low battery is indicated by the safe
beeping four times whenever the door is
opened, and by the indicator light flashing red.
4. When low battery is indicated,
change the batteries.