Product manual

SKU 92192 For technical questions, please call 1-800-444-3353. Page 4
Installation
1. Install this unit only on a window that can be opened with less than 15 lbs. of pressure.
Be careful not to force this unit during installation. Forcing this unit open or shut may
cause irreparable damage.
2. There are two methods of installation; either or both can be used on a given installa-
tion:
Figure 1
Unit shown from underneath, installed to
the window of Sku 47712 - greenhouse
- using the two predrilled holes and
screws included with the greenhouse.
Using Hardware
a. For hardware installation, two predrilled holes are
needed. The holes must be
3
/
16
” diameter or smaller,
and spaced 1-
1
/
16
” apart (center-to-center). Also, two
screws (or bolt and nut pairs) appropriate for the mount-
ing surface are also needed. Washers may also be
necessary.
b. Place the appropriate Bracket (3 or 4) up against the
work surface (window frame for Upper Bracket (4) or
window sill for Lower Bracket (3)).
c. Install the hardware securely, being careful not to over-
tighten. See Figure 1, right.
Using Mounting Clamp
a. Insert 2 Screws (5) though the appropriate Bracket (3
or 4) and thread into the Clamping Plate (6).
b. The edge that this unit is mounted on cannot be thicker
than
1
/
8
”.
c. Fit the Clamping Plate (6) over the edge on the window
(if the Upper Bracket (4) is being attached), or on the
window sill (if the Lower Bracket (3) is being attached).
d. Tighten both Screws securely. See Figure 2, right.
Figure 2
Unit shown from underneath, installed to
the window sill of Sku 47712 - Green-
house - using Clamping Plate (6) and
Screws (5).