Product manual

Page 8 For technical questions, please call 1-800-444-3353. SKU 95793
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of
this manual including all text under
subheadings therein before
set up or use of this product.
Inspect tool before use, looking for damaged,
loose, and missing parts. If any problems
are found, do not use tool until repaired.
Work Piece and
Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children

2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. 

nearby that will present a hazard while working.
CAUTION! Prior to sandblasting, protect other people

providing barriers or shields. Wear appropriate clothing
and safety gear when operating the Abrasive Blast Gun.
General Operating Instructions
1. If possible, place the workpiece inside a sandblast
cabinet (not included). Otherwise, isolate the
workpiece to make sure no damage can occur to
nearby walls, tools, equipment, or other property.
2. Remove the cap from the Hopper (19)

WARNING! Do not use sand
(crystalline silica) for blasting.
3. 
NOTE: To keep the beads from accidentally spilling
out of the Nozzle, do not point the Nozzle downward
.
4. Connect the compressor’s air hose to the
pre-installed quick connector on the Blast Gun.
Turn the compressor’s regulator to 90 PSI.
WARNING! Do not exceed 90 PSI.
5. Turn on the compressor, turn the Regulator (17) to

NOTE: Test the spray pattern and intensity of
the Blast Gun on a piece of scrap material.
6. 
to be sandblasted. Then squeeze the
Trigger (4) to turn on the Blast Gun.
7. 
Turn off the air compressor and squeeze
the Trigger once again to release any

8. 
on the Trigger. Turn off the air compressor. Squeeze
the Trigger once to release any compressed air.
Disconnect the Blaster Gun from its air supply.
9. Dispose of used abrasive media only
according to local solid waste guidelines.
10. Clean, then store the tool indoors
out of children’s reach.