Product manual

Page 5SKU 47844
4. With the Table Top still upside down, slide the Leg Frames (8) into the Slide Base (3)
as shown in photos [A] and [C]. Both Slide Base handles should face forward.
Guide the Bolts (10), with Washer (11), into the Slide Base side holes (from the
outside), and through the Leg Frames. With the Bolts protruding out from the other
side of the Slide Base, insert Washer (11) and Nuts (12). Tighten securely.
5. Attach the Handles to each Slide Base (3), if not already attached. Turn each Handle
to widen the Table Top.
6. Place the Workbench right side up, and place the four Material Stops (13) in the
desired location. See photo [D]. Locate the Foldable Workbench on a flat, level, solid
surface that is capable of supporting the workbench and it’s maximum weight capacity
oFf 260 lbs.
7. When you are finished using the Workbench, press down on one side of the Table Top
to collapse and fold the Workbench for storage. See photo [E].
8. Store in a clean and dry location.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFER-
ENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WAR-
RANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT
OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDER-
TAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
(8)
(11) (12)
(3)
(10)
[C]
(13)
[D]
[E]
REV 10c