Product manual

Page 4SKU 47844
be of the proper size and type to supply the correct current to the tool without heating
up. Otherwise, the extension cord could melt and catch fire, or cause electrical
damage to the tool. Longer extension cords require larger size wire. If you are using
the tool outdoors, use an extension cord rated for outdoor use. (signified by “WA” on
the jacket).
21. Pacemaker safety warning. People with pacemakers should consult with their
physician(s) before using certain electric tools; operation of equipment in close
proximity to a heart pacemaker could cause interference or failure of the pacemaker.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that all the parts are included. Refer to the Parts List.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Assembly
1. Turn the Table Top (1) pieces upside down and attach each Slide Base (3) as shown
below. Use the Wood Screws (2). See photo [A]. Tighten securely.
2. Attach the Cross Bar (7) to each Leg Frame (8). Use Bolts (4), Washers (5), and Nuts
(6). See photo [B]. Tighten securely.
The Leg Frames (8) are labeled left (L) and right (R) and must be aligned before
placing the Cross Bar.
3. Push the Rubber Pads (9) onto the Leg Frame (8) feet. See photo [B].
(2)
Right Front
[A] [B]
(2)
(3)
(7)
(8)
(4)
(5),(6)
(9)
Left Front
(10)