Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 47410
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the On/Off Button is in the OFF position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM LIGHT FAILURE:
Do not use damaged equipment. If damage is noted, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the light. Check for:
• loose hardware,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, allow Light to cool and then wipe
external surfaces of the Light with a clean cloth.
3. To replace the Bulb, first allow the Light to cool
completely. Do not touch the Bulb at any time.
Use a soft cloth instead. Oil from skin may
damage the Bulb. See Bulb installation instructions
in Setup - Before Use: on page 5.
WARNING! If the supply cord of this
light is damaged, it must be replaced only
by a qualified service technician.
6. Remove both Bracket Knobs (20) from the
Cross Bar (19). Line up the hole in the bottom
of the lamp assembly Bracket (15) with a hole
on the right or left side of the Cross Bar (19).
Insert a Bracket Knob (20) and tighten. Repeat
for the other lamp assembly. See Figure B.
7. Pull the shipping covers off of the
Power Buttons (54) on each lamp.
20
19
Figure B
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
1. To tilt the Light vertically, loosen the
Adjusting Knob (12), rotate the Light to the desired
position, and tighten the Adjusting Knob.
2. To pivot the Light horizontally, loosen the
Bracket Knob (20), slide the Light to the desired
position, and tighten the Bracket Knob.
3. Plug the Light into a standard,
grounded 120V electrical outlet.
4. Press the Power Buttons on the back
of the units to turn on each Light.
WARNING! Point the Light away from any walls.
Keep the Light away from combustible objects. The
Light and housing will get hot enough to start a fire.
5. To prevent accidents, turn off the Light and
disconnect its power supply after use. Clean, and
then store the Light indoors out of children’s reach.
Record Product’s Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
Note: Some parts are listed and shown for
illustration purposes only, and are not available
individually as replacement parts.