Product manual

Item 95205 For technical questions please call 1-888-866-5797. Page 3
Warning: The warnings, cautions, and instructions discussed in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by the
operator.
UNPACKING
When unpacking your Digital Timer, check to make sure that the product is intact and undamaged.
If any parts are missing or broken, please call Harbor Freight Tools at: 1-888-866-5797. Keep this
manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and
cleaning procedures. Write the product’s serial number in the back of the manual (or month and year
of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for
future reference.
OPERATION
Note:
Week
Hour
R (to undo a setting)
Minute
Clock
Program
On-Auto-Off
LCD Readout
Figure 1
Before using the Digital Timer, it must be the plugged in for 15 minutes to allow the internal
battery to charge. After recharging press, the “R” button to reset the unit. For the location of all
buttons on the Digital Timer, please refer to Figure 1.
Note: The Digital Timer uses Military Time (24 hour clock). All times must be entered using Military
Time. See Standard Time To Military Time Conversion Chart on page 4.
Setting the Clock to the Actual Time
1. To set the Hour: Press the CLOCK and HOUR buttons down at the same time. The Digital Timer
will circulate through each hour. Release the buttons once the current HOUR is selected. See the
military Time Chart on page 4.
2. To set the Minutes: Press the CLOCK and MIN buttons down at the same time. Release the
buttons once the current time in minutes comes up on the Digital Timer. Standard Time To Military
Time Conversion Chart on page 4.