Product manual

OPERATING
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of
this manual including all text
under subheadings therein
before set up or use of this
product.
Select the Die that is appropriate 1.
for the job. The large grooved Die
(22) is for bending small tubes.
The small grooved Die (23) is for
bending small round stock. The
square Die (24) is used to bend at
stock.
Raise the Handle (7) and place the 2.
Die into the slots between the Right
Frame (3) and Left Frame (4).
Insert the stock or tube into the top 3.
of the Bender and thread it into the
appropriate groove between the
Die and the Base Block (6).
The Square Die (24) placed into 4.
the recess in the front of the unit
will provide further support for stock
being bent.
Move the Handle slowly down until 5.
the stock is at the desired angle.
See Figure 1.
FIGURE 2
SKU 99826 For technical questions, please call 1-800-444-3353. Page 5