Product manual

Page 8SKU 96997 For technical questions, please call 1-800-444-3353.
FIGURE C
COMPRESSED
AIR SUPPLY HOSE
(NOT INCLUDED)
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
1. CAUTION! Prior to using the Scaler, make sure to wear ANSI-
approved safety impact goggles, dust mask or respirator, and
heavy duty work gloves.
Use clamps (not included) or other practical ways to secure and support the 2.
workpiece to a stable platform. Holding the work by hand or against your body is
unstable and may lead to loss of control.
Grip the Scaler with both hands. Make sure the Needles (16) are not touching 3.
any surface before you turn on the tool. Then squeeze the Throttle Lever (6) and
allow the Needles (16) to vibrate to their fullest speed. (See Figure D.)
Place the vibrating Needles (16) on the surface residue. Then, move the Scaler 4.
around the area to remove the residue. To increase the intensity of the vibrating
Needles, squeeze the Throttle Lever (6) harder. To decrease the intensity of the
vibrating Needles, relax pressure on the Throttle Lever. (See Figure D.)
Keep a light pressure on the Scaler when in use. Do not apply heavy pressure, 5.
as damage to the work surface may result.
OPERATING INSTRUCTIONS
Connect a compressed air supply hose (not included) to the previously installed 3.
Quick Connector. Then turn on the air compressor, and set its regulator to 90
PSI. Do not exceed 90 PSI. (See Figure C.)
FIGURE D
THROTTLE LEVER (6)NEEDLES (16)