Product manual

Page 3For technical questions, please call 1-888-866-5797.Item 37349
5. This product may not meet D.O.T. requirements
for use on public roads or highways. Follow
local, state, and federal regulations.
6. The warnings and precautions discussed in this
manual cannot cover all possible conditions
and situations that may occur. The operator
must understand that common sense and
caution are factors that cannot be built into this
product, but must be supplied by the operator.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
document including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 6.
Light Mounting
1. To avoid accidental short circuits,
disconnect the negative (-) terminal of
the vehicle battery prior to installation.
2. Driving lights must be mounted between 16"
and 42" from the ground. Fog lights must be
mounted between 12" and 30" from the ground.
Check state and local regulations for minimum
and maximum mounting height requirements.
3. The Halogen Lights can be mounted above
or below the bumper. Make sure the
desired mounting locations do not obstruct
the vehicle’s headlights or turn signals.
4. If mounting below the bumper, perform
following procedure to maintain
the optimum beam pattern:
a. Remove two Screws (1), Lens
Holders (2), and the Glass Lens (3)
from the front of each Light.
b. Pull out the Reflector (5) from the Light
Housing (8), turn 180 º and put back into
the Housing in the reverse position.
c. Turn the Glass Lens 180 º, reinstall on
the Light Housing and secure in place
with the Lens Holders and Screws.
5. Place the Halogen Lights on the bumper, and
mark the desired mounting locations at an
equal distance from the center of the bumper.
6. Drill 1/2" diameter holes through
pre-marked mounting positions.
CAUTION: Make sure no electrical wires or
cables are in the way of the drilling path.
7. Install the Lights on the bumper, using
the Bolts (10), Attachment Plates (11),
Lock Washers (12), and Nuts (13).
8. Align Lights to desired angle and tighten
the Nuts to retain aiming position.
9. Mount the Light Switch (14) in a location
that is within easy reach (i.e., dashboard,
console). With the Light Switch in the
desired position, mark the holes for drilling
and drill two 1/16" holes. Mount the Light
Switch with the Screws provided.