Product manual

Page 7For technical questions, please call 1-800-444-3353.Item 60739
Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
The Dust Reclaimer Kit can be attached to a wall surface (see instructions below), or it
can be mounted to the back of 60738 Industrial Blast Cabinet (see page 10).
How To Install The Dust Reclaimer To A Wall
IMPORTANT: The Wire Mesh Reinforced Hose (16B) supplied with the Dust Reclaimer is 3 feet long.
When determining a permanent location for the 60738 Blast Cabinet, make sure the Blast Cabinet is within
3 feet of the wall surface on which the Dust Reclaimer will be mounted. (See Figure 7, page 13).
NOTE: You may wish to connect a longer Wire Mesh Reinforced Hose (not included) between the Blast Cabinet
and Dust Reclaimer. If so, make sure the longer Hose has a 2″ diameter, and use a proper extension cord
to connect the Power Cord Plug (12) of the Dust Reclaimer to the Lamp Housing on the Blast Cabinet.
1. Open the right side door of the blast cabinet.
Remove the four screws on the exhaust board.
Take out the exhaust board (see Figure A).
Exhaust
Board
Figure A
2. Install the Hose Connector (48) using four
M5x12 bolts (47) as shown in Figure B below.
Hose
Connector
(48)
Bolts (47)
Figure B
3. Re-install the Exhaust Board over the
Hose Connector (48) (see Figure A).