Product manual

Page 10 For technical questions, please call 1-800-444-3353. Item 60739
How To Install The Dust Reclaimer To A Blast Cabinet (60738)
1. Open the right side door of the blast cabinet.
Remove the four screws on the exhaust board.
Take out the Exhaust Board (see Figure G).
Exhaust
Board
Figure G
2. Install the Hose Connector (48) using
four Bolts (47) as shown in Figure H.
Hose
Connector
(48)
Bolts (47)
Figure H
3. Re-install the Exhaust Board as shown in Figure G.
4. Assemble the two Support Brackets (32) to the
Housing (22A) using Bolts (28), Spring Washers (29),
Washers (30), and Nuts (31). Do not tighten the
Nuts (31) completely at this point. See Figure I.
5. Place the Support Brackets (32) on a flat
surface. Adjust the position of the support
brackets and the Dust Reclaimer hose nozzle
until it looks like it does in Figure I.
6. Make sure the Support Brackets are parallel
with the dust collector hose nozzle. After
ensuring the support brackets center line is
in line with that of the dust collector hose,
firmly tighten the Nuts (31). See Figure I.
Housing
(22A)
Support
Bracket (32)
Bolt (28)
Washer (30) x2
Spring Washer (29)
and Nut (31)
Support
Bracket (32)
Figure I