Product manual

Page 13For technical questions, please call 1-800-444-3353.SKU 42202
Note: Use caution when sandblasting
unfamiliar material. Test the tool on
a small area before proceeding. This
will ensure you will not damage or pit
the material you wish to sandblast.
WARNING: Do not aim the gun at your
ngers or the Blast Gloves. Do not
operate the gun with the Side Door
open or outside of the Blast Cabinet.
If the tool requires more force to 8.
accomplish the task, verify that the
tool receives sufcient, unobstructed
airow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool’s maximum
air pressure rating.
If the tool still does not have sufcient
force at maximum pressure and
sufcient airow, then a larger tool
may be required.
Once completed, remove your hands 9.
from the Gloves and shut off the
compressor. Open the Side Door and
remove your material from the Blast
Cabinet.
To prevent accidents, turn off the 10.
tool, detach the air supply, safely
discharge any residual air pressure in
the tool, and release the Trigger after
use. Clean external surfaces of the
tool with a clean, dry cloth, and apply
a thin coat of tool oil. Then store the
tool indoors out of children’s reach.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Release the Trigger, detach
the air supply, safely
discharge any residual air
pressure in the tool, and
release the Trigger again
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
Cleaning and Maintenance
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular
operation of the air-operated tool.
Changing the Blasting Medium
It is not necessary to remove the
blasting medium from the Hopper
(13) after every use. However, clean
out the Hopper when a different
blasting medium is to be used or
when the medium gets worn down.
To clean the Hopper: