BACKPACK SPRAYER 12 VOLT - 4.8 GAL. CAPACITY Model 94573 Set up and Operating Instructions Visit our website at: http://www.harborfreight.com Read this material before using this product. Failure to do so can result in serious injury. Save this manual. Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
NOTICE is used to address practices not related to personal injury. Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
. 4. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the Sprayer in unexpected situations. Wear eye, breathing, and skin protection. Wear ANSI approved safety impact goggles, a NIOSH-approved respirator, latex gloves, and proper safety clothing when using this product. SERVICE 1. Product service must be performed only by qualified service technician.
6. 7. 8. 9. Always follow all chemical label precautions and local EPA regulations when using liquid chemicals. Do not touch harmful chemicals. After use, clean the Sprayer thoroughly with agents recommended by the chemical manufacturer. Never point the nozzle of the Spray Gun Assembly at yourself, other people, pets and animals, or property. A note on Chemicals disposal: Never attempt to burn unused fertilizers, herbicides, pesticides, or any other types of chemicals.
the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. Double Insulated Tools: Tools with Two Prong Plugs Symbology Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. V~ A Volts Alternating Current Amperes No Load Revolutions per Minute n0 xxxx/min. (RPM) Outlets for 2-Prong Plug 1.
SPECIFICATIONS Charger Input Charger Output Battery Type Charge Time Charger Cord/Plug Spray Time Output Tank Capacity Flow Rating Maximum Pressure Unit Dimensions Spray Rod Dimensions Unit Weight (Empty) Accessories Additional Features FIGURE E CHARGER (63) 120 V~ / 60 Hz 12 VDC Rechargeable 12V / 10 Ah 8 Hours 58-1/2” L, 2-Prong Approximately 9 to 10 Hours (Full Charge) 4.8 Gallons 0.
ASSEMBLY AND OPERATING INSTRUCTIONS FOUR HOLE ADJUSTABLE NOZZLE (62) CAUTION! Wear eye, breathing, and skin protection. Wear ANSI-approved safety impact goggles, a NIOSH-approved respirator, latex gloves, and proper safety clothing when using this product. FIGURE H c. Four Hole Adjustable Nozzle (62): Designed for spraying high crops and fruit trees and the spraying of pesticides. However, the Adjustable Nozzle may result in significant overspray of pesticides. (See Figure H.
be sprayed. Then, squeeze the Trigger to begin spraying. (See Figure L.) To Fill The Tank: TANK CAP (41) NOTE: The Trigger (17) of the Spray Gun Assembly may be locked in a continuous run position with the Trigger Lock (16). To do so, move the Trigger Lock backward toward the Handle (21). To return to manual operation, move the Trigger Lock forward toward the Spray Rod (9). (See Figure L.) TANK FILTER (42) TANK (64) FIGURE K 1.
INSPECTION, MAINTENANCE, AND CLEANING CAUTION! Make sure the Power Switch (58) is in its “OFF” position and unplugged from its Charger (63). Then, de-pressurize the system before performing any inspection, maintenance, or cleaning of the Sprayer. 1. Before each use, inspect the general condition of the Sprayer.
PARTS LIST Part 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 Description Nozzle Nut Conical Mist Spraying Sheet Splitting Sheet Nozzle Gasket Ring Elbow Spray Rod O-Ring Opening Cover Spray Rod Nut Spray Rod Switch Main Unit Switch Gasket Valve Cartridge O-Ring Valve Cartridge Spring Switch Nut Trigger Lock Trigger Switch Pin Handle Gasket Ring Switch Filter Screen Handle Opening Cover Tube Sleeve Hose Caster Screw (M5 x 20) Flat Washer (#5) Nut (M5) Protection
ASSEMBLY DIAGRAM 40 41 60 1 23 42 43 4 5 6 44 7 8 45 61 9 64 65 11 12 62 39 46 10 13 63 47 49 48 52 36 35 59 58 55 54 57, 56 20 34 50 31 28, 27, 26 21 22 23 32 33 16 18 19 37 53 15 17 38 51 14 29 30 24 25 NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Rev 10d SKU 94573 For technical questions, please call 1-800-444-3353.
