Product manual

Page 8 Fo r t e c h n i c a l q u e s t i o n s , p l e a s e c a l l 1 - 8 8 8 - 8 6 6 - 5 7 9 7 . Item 61612
Co m m o n Pr o b l e m s a n d Re m e d i e s
1. Ir r e g u l a r D a r k e n i n g Or D i m m i n g
a. Headband has been set unevenly on both sides of helmet (unequal distances from the eyes to filter’s lens).
b. Reset Headband to reduce difference in distances to filter, if necessary.
2. Au t o - D a r k e n i n g Fi l t e r D o e s No t D a r k e n Or Fl i c k e r s
a. Front Lens Cover is soiled or damaged (change the cover).
b. Sensors are soiled (clean surface of the sensors).
c. Welding current is too low (turn Sensitivity Adjustment Knob to the “MAX” position, if necessary).
3. Sl o w Re s p o n s e
a. Operating temperature is too low (do not use at temperatures below 14° F).
4. Po o r V i s i o n
a. Front/Inside Lens Cover and/or Filter soiled (change it).
b. Insufficient ambient light.
c. Shade number is incorrectly set (reset shade number).
5. W e l d i n g H e l m e t Sl i p s
a. Headband is not adjusted properly (must be lowered).
St o p u s i n g t h e H e l m e t i m m e d i a t e l y i f a n y o f t h e m e n t i o n e d p r o b l e m s c a n n o t b e c o r r e c t e d .
SAFETY OPERATION MAINTENANCESPECIFICATIONS