Product manual
Page 5For technical questions, please call 1-888-866-5797.Item 37350
Aiming Beams
1. Driving lights must be aimed with the center of
the high intensity zone on a vertical line, straight
ahead of the light center and with the top edge
of the beam 2 inches below the level of the light
center at a distance of 25 feet from the lens.
2. Fog lights must be aimed with the center of the
high intensity zone on a vertical line straight
ahead of the lamp center and with the top edge
of the beam 4 inches below the level of the light
center at a distance of 25 feet from the lens.
NOTICE: Incorrectly aiming beams may present
a hazard to other drivers and may be illegal.
Follow local, state, and federal regulations.
Halogen Bulb Replacement
1. To avoid accidental short circuits, disconnect
the negative (-) terminal of the vehicle
battery prior to bulb replacement.
2. Disconnect the White bulb wire from the
double female "Y" connector of the 6 ft. White
extension wire or from the single female
connector of the 3 ft. Blue extension wire
(depending on which bulb is being replaced).
Refer to Figure A: Wiring Diagram.
3. Remove two Screws (18) from the sides
of the Light Housing (9), then remove
the Lens Holder (1) and Glass Lens (3)
from the front of the Light. Refer to Parts
List and Diagram on page 6.
4. Pull out the Reflector (8) from the Light
Housing. Remove the Spring Clip (6) holding
the Bulb (5) in place on the Bulb Holder (7).
5. Remove the old Bulb from the Bulb
Holder and replace with an identical
12 V 55 W H3 halogen bulb.
CAUTION: Do not touch the Bulb with your bare
hands; oil from skin will drastically shorten the life
span of the bulb if not cleaned with rubbing alcohol
and allowed to dry before use. Handle the bulb with
a soft, clean cloth or clean work gloves instead.
6. Secure the new Bulb in place on the
Bulb Holder with the Spring Clip.
7. Thread the new White bulb wire through
the Grommet (11) on the Light Housing and
insert the Reflector back into the Housing.
Replace the Glass Lens and Lens Holder.
Secure in place with the two Screws.
8. Insert the male connector end of the
White bulb wire into the double female
"Y" connector of the 6 ft. White extension
wire or into the single female connector
of the 3 ft. Blue extension wire.
9. Check that all wiring is identical with
Figure A: Wiring Diagram, then reconnect
negative (-) terminal of the vehicle battery.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.