Product manual

Page 4 For technical questions, please call 1-888-866-5797. Item 37350
Wiring Installation
1. Connect the Black ground wire from
each Light to the chassis or any other
grounded metal surface of the vehicle.
2. Insert the male connector end of the White
bulb wire from one Light into double female
"Y" connector of 6 ft. White extension wire.
3. Insert the male connector end of the White
bulb wire from the other Light into single
female connector of 3 ft. Blue extension wire.
4. Insert the male connector end of Blue
extension wire into double female "Y"
connector of White extension wire.
5. Insert "U" spade connector end of White
extension wire into one Light Switch terminal.
6. Insert "U" spade connector end of 5 ft.
Black power supply wire with 15 A in‑line
fuse into other Light Switch terminal. The
other end of the Black power supply wire
must be connected to the positive (+)
terminal of battery or vehicle fuse box.
7. Use plastic tie-strips (not included) to secure
the wiring throughout the vehicle. Avoid hot
areas and moving parts. Tape all connections
using electrical tape (not included). Protect the
wiring from sharp edges with tape or grommets.
8. A 15 amp fuse must be installed
inline on the positive power supply
wire of this item. Using no fuse, or
using an incorrect fuse can cause an
electrical fire.
9. Check that all wiring is identical with
Figure A: Wiring Diagram, then reconnect
negative (-) terminal of the vehicle battery.
Turn on the Light Switch to confirm
the Lights are operating properly.
Blue
extension
wire
Black
ground
wire
To ground
White extension wire
To ground
"Y" Connector
Light
Switch
Black power supply wire
To fuse box
or positive (+)
terminal of battery.
15 A Fuse
Black
ground
wire
White bulb
wire
White bulb
wire
Lamp Lamp
Figure A: Wiring Diagram