Product manual

For technical questions, please call 1-800-444-3353.
Page 6SKU 00219
Grease Loading Instructions
Warning!! Make sure the Grease Gun is not attached to the air source hose when
loading grease.
Grease can be loaded into the Grease Gun by loading with a filler pump (FIGURE 1), using
suction filling (FIGURE 2), or loading with a cartridge (FIGURE 3).
Loading a grease cartridge (not included).
See the Assembly Drawing on page 10, Figures A, B, and C on page 5 and
FIGURE 3 below.
1. Remove the Tube (18) from the top of the Front Housing (7).
2. Pull back on the Handle (21) until it is fully extended. Lock it into place with the Locking
Plate (20).
3. Remove the caps/lids from both ends of the cartridge (not included). Insert the cartridge
into the Tube (18) in the orientation indicated on the cartridge, making sure that it is in
as far as possible.
4. Reassemble the Tube (18) to the top on the Front Housing (7). Press the Locking Plate
(20) and release the Handle (21). Press the Handle (21) in as far as it will go.
Suction Filling (FIGURE 2)
See the Assembly Drawing on page 10, Figures A, B, and C on page 5 and
FIGURE 2 above.
1. Remove the Tube (18) from the top of the Front Housing (7).
2 Submerge the open end of the Tube (18) approximately 2 inches into the grease
container (not included).
3. Slowly, pull back and fully extend the Handle (21) to draw grease upward into
the Tube (18). When the Handle (21) is fully extended, lock it into place with the
Locking Plate (20).
4. Carefully, reassemble the Tube (18) to the top on the Head (7). Press the Locking
Plate (20) and release the Handle (21). Press the Handle (21) in as far as it will go.
FIGURE 1 FIGURE 2
FIGURE 3
Suction Filling Cartridge Filling
Filler Pump Filling
Filler Hose with
Plug on the Pump
(not included)
enters the
Nozzle (10)
Cartridge
Tube (18)
Nozzle
(10)
REV 05g