Product manual
Page 8 For technical questions, please call 1-800-444-3353. ITEM 60491
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Detach the air supply and safely discharge any
residual air pressure in the tool before performing
any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or
component in a way not specically explained
within this manual. Improper adjustment can
result in tool failure or other serious hazards.
Work Piece and
Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. There must not be hazardous objects (such
as utility lines or foreign objects) nearby that
will present a hazard while working.
CAUTION! Prior to sandblasting, protect other
people (and property) in the work area from
ying debris by providing barriers or shields.
Always wear appropriate clothing and safety
gear when operating the Deadman Valve.
General Operating Instructions
1. If possible, place the workpiece inside a sandblast
cabinet (not included). Otherwise, isolate the
workpiece to make sure no damage can occur to
nearby walls, tools, equipment, or other property.
2. Install the desired size Ceramic Nozzle (37) and
Rubber Adapter (38) on the Deadman Valve.
4. Connect the grit supply hose to the Valve.
To keep the grit supply hose out of the
way, hang it over your shoulder.
5. Turn on the sandblaster unit (not included).
6. Grip the Valve rmly, aim it at the workpiece, and
squeeze the Trigger (42) while slowly moving
the tool in a circular or right to left motion.
7. Continue moving in a circular or right to left
motion until you have achieved the desired
appearance (nish) on the workpiece.
8. When the sandblasting job is completed,
release pressure on the Trigger (42) to turn off
the Valve. Turn off the sandblaster unit.
9. Turn off the air compressor. Squeeze the
Trigger once to release any compressed air.
Disconnect the Valve from its air supply.
10. Clean, then store the tool indoors
out of children’s reach.