User Guide

SKU 93507 For technical questions, please call 1-800-444-3353. Page 28

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST

AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI-

THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION

OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO

REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/

OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-

MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,

AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY

ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR RE-

PLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION

OF REPLACEMENT PARTS THERETO.

PLEASE READ THE FOLLOWING CAREFULLY

8. WARNING! All maintenance, service, or repairs not mentioned in this

manual must only be performed by a qualiﬁed service technician.

7. To clean the exterior parts of the Bandsaw, use only a clean cloth and mild

detergent or mild solvent to clean the body of the Saw. Do not immerse any

electrical part of the machine in any liquids.

COOLANT TANK

(107)

HOSE

(102)

WHITE LID

FIGURE Z

Remove the white lid at the top of the Coolant Tank (107), and dispose of the

old Coolant properly in a container. (See Figure Z.)

Fill the Coolant Tank (107) to about 80% capacity with a clean water-soluble

coolant (not included). Then, replace the white lid on the Coolant Tank.

(See Figure Z.)

Slide the Coolant Tank (107) back under the Table (39) of the Bandsaw. Then

insert the Hose (102) through the hole in the white lid. (See Figure Z.)