User Guide

SKU 93507 For technical questions, please call 1-800-444-3353. Page 20
Adjusting The Blade Guide Brackets:
1. The Right Adjustable Bracket (132) and Left Adjustable Bracket (163) are adjust-
able by loosening the two Guide Adjusting Knobs (131) and sliding the Brackets
to accommodate the width of the workpiece. (See Figure T.)
2. The Blade Guide Brackets (132, 163) should be set as close as possible to the
workpiece, without interfering with the workpiece or contacting the Table (39).
(See Figure T.)
3. Once the adjustment is made, make sure to retighten the Guide Adjusting Knobs
(131). (See Figure T.)
GUIDE ADJUSTING
KNOB
(131)
GUIDE ADJUSTING
KNOB
(131)
RIGHT
ADJUSTABLE
BRACKET (132)
LEFT
ADJUSTABLE
BRACKET (163)
FIGURE T
Basic Bandsaw Operation -- Vertical Position:
1. WARNING! Always wear ANSI approved safety impact eye goggles when
operating the Bandsaw.
2. Do not plug the Power Cord Plug (38) into an electrical outlet until all nec-
essary adjustments (as previously discussed in this manual) have been
made.
3. Raise the Saw Head to its full vertical position, making sure it locks in place by
turning the Hydraulic Cylinder (20) to its “OFF” position.
(See Figure U, next page.)
4. Once all necessary adjustments to the Bandsaw have been made, plug the
Power Cord Plug (38) into the nearest 120 volt, grounded, electrical outlet (if
the Bandsaw is powered by a 120 volt system). If powered by a 230 volt system,
plug the Power Cord Plug into the nearest 230 volt, grounded, electrical outlet.