User Guide

SKU 93507 For technical questions, please call 1-800-444-3353. Page 16
Adjusting The Quick Vise For An Angle Cut:
Loosen the three Screws (99). Adjust the Rear Vise (95) to the threaded hole
position. Set the Scale (100) to the desired angle. Adjust the Front Vise (94) to
parallel the Rear Vise. Then, retighten the three Screws. (See Figure M.)
FRONT VISE
(94)
SCREW
(99)
TABLE
(39)
THREADED HOLE
REAR VISE (95)
SCREW (99)
SCREW (99)
SCALE
(100)
FIGURE M
Adjusting The Stop Block:
Loosen the Thumb Screw (72) that holds the Stop Block (73) to the Stock Stop Rod
(74). (See Figure N.)
Adjust the Stop Block (73) to the desired length position. Then, retighten the Thumb
Screw. (See Figure N.)
1.
2.
FIGURE N
THUMB SCREW (72)
STOP BLOCK (73)
STOCK STOP ROD (74)
(WORKPIECE NOT INCLUDED)