User Guide

SKU 93507 For technical questions, please call 1-800-444-3353. Page 13
D - Attach The Tool Stop Rod And Block
Slide the Stock Stop Rod (74) into the mounting hole in the Table (39), and
secure the Stock Stop Rod by tightening the Set Screw (71). (See Figure G.)
Slide the Stop Block (73) onto the Stock Stop Rod (74), and secure by tightening
the Thumb Screw (72). (See Figure G.)
1.
2.
FIGURE G
STOP BLOCK
(73)
THUMB SCREW (72)
STOCK STOP ROD (74)
SET SCREW
(71)
(WORKPIECE NOT INCLUDED)
E - Install The Coolant Tank
Slide the Coolant Tank (107) out from under the Table (39) of the Bandsaw.
(See Figure H.)
Remove the white lid at the top of the Coolant Tank (107), and fill the Coolant
Tank to about 80% capacity with a water-soluble coolant (not included). Then,
replace the white lid on the Coolant Tank. (See Figure H.)
Slide the Coolant Tank (107) back under the Table (39) of the Bandsaw. Then
insert the Hose (102) through the hole in the white lid. (See Figure H.)
1.
2.
3.
COOLANT TANK
(107)
WHITE LID
HOSE (102)
FIGURE H