User Guide

SKU 93507 For technical questions, please call 1-800-444-3353. Page 12
C - Attach The Pulley Cover
Slide the two openings in the Pulley Cover (189) under the two Pulleys (184, 185).
Secure the Pulley Cover, using one Screw (187) and one Washer (188). Then close
the lid of the Pulley Cover, and secure the lid with the Thumb Screw (190).
(See Figure F.)
PULLEY COVER (189)
SCREW (187)
WASHER (188)
THUMB SCREW
(190)
FIGURE F
WHEEL
(34)
WHEEL SHAFT
(35)
COTTER PIN
(36)
WASHER
(33)
(END VIEW)
WHEEL (34)
LEFT LEG
(2)
RIGHT LEG
(3)
WHEEL (34)
FIGURE E
B - Remove The Shipping Bolt
Turn the lever on the Hydraulic Cylinder (20) to the “OFF” (horizontal) position.
Remove Hex Head Screw (170) that holds the Bracket (172) to the Saw Arm. Save
this Screw for any future transport.
Check that the Saw arm prevents the Toggle Switch (37) from entering its “ON” posi-
tion. If it does not, adjust the Stop Screw (60) to lower the Saw Arm until it does.
Make certain that the blade cannot contact the table with the Saw Arm lowered
completely. If it can, adjust the Stop Screw (60) to raise the Saw Arm.
1.
2.
3.
4.
REV 10/06