Product manual

Page 13For technical questions, please call 1-888-866-5797.Item 69336
SAFETYOPERATIONMAINTENANCE SETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and remove the battery pack before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1� BEFORE EACH USE, inspect the general
condition of the tool� Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation�
2� AFTER USE, wipe external surfaces
of the tool with clean cloth�
3� Protect the tool and its parts and
accessories from moisture and humidity�
4� Some of the bits provided are “grinding bits”
using stone abrasives� During use, these
may clog up with removed material or
lose their shape� To clean and reshape
these bits, run them against the provided
Dressing Stone� The Dressing Stone will
abrade away the clogging materials and will
reshape the Grinding Bits as appropriate�
5� NiCd BATTERY MUST BE RECYCLED
OR DISPOSED OF PROPERLY�
Do not short, incinerate or open battery�
6� Dispose of used batteries properly�
Consult your local hazardous waste
authority for disposal guidelines�
7� To change the batteries in the LED Collar:
a� Remove it from the Rotary Tool�
b� Using a cross head screwdriver, open the
battery compartment�
c� Replace the batteries with the same type as
originally installed (Two CR-927, 3V
batteries)� Be sure to match the polarity
marking in the battery compartment�