Product manual

Page 12 For technical questions, please call 1-888-866-5797. Item 69336
SAFETY OPERATION MAINTENANCESETUP
WORKPIECE AND WORK AREA SET UP
1� Designate a work area that is clean
and well-lit� The work area must not
allow access by children or pets to
prevent distraction and injury�
2� Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage� The power cord must
reach the work area with enough extra length
to allow free movement while working�
3� Secure loose workpieces using
a vise or clamps (not included)
to prevent movement while working�
4� There must not be objects,
such as utility lines, nearby that will
present a hazard while working�
GENERAL OPERATING INSTRUCTIONS
1� Charge the Battery Pack (18) and insert it in
the tool, as described in the previous section�
2� Select an appropriate bit or attachment
for the job� Insert the bit or attachment
as described in the previous section�
3� The LED Collar may be turned on by
moving the switch on the collar�
4� Rotate the Switch (8) to the ON position�
This is a variable speed switch� The tool
bit speed is dependent on the position of
the Switch� Use a speed appropriate to
the bit and the material being worked on�
In general, harder materials require faster
speeds and softer materials require slower
speeds� Relative speeds are indicated
by the numbers on the Switch�
5� Apply the tool bit to the work
material as needed�
6� When the task has been completed, stop the
tool by rotating the Switch (8) to the OFF (“O”)
position� If the LED Collar is ON, switch it OFF�
Unplug the rechargeable battery�
Remove the bit or attachment as
discussed in the previous section�
7� Store the tool, its battery, and its bits and
attachments in their case in a safe location�