Product manual

Page 11For technical questions, please call 1-888-866-5797.Item 69336
SAFETYOPERATIONMAINTENANCE SETUP
Installing the Flexible Shaft
1� Turn the Rotary Tool OFF (the “O” position),
and remove the Battery from
the Handle before attaching the
Flexible Shaft Attachment (26)�
2� Remove any bits that might be installed�
Remove the Collet Lock Nut and the Collet�
3� Remove the Collar or LED Collar from the
tool Body by turning it counterclockwise�
4� Pass the end of the Flexible Shaft Core
through the Collet Nut, and into the 1/8″ Collet.
Depress the Spindle Lock (10), and
hold it down while tightening the
Collet Nut with the Wrench�
5� When the Collet Nut is tight, release
the Spindle Lock (10) and turn the
Flexible Shaft Attaching Nut clockwise
onto the tool body until hand tight�
Installing a Bit in the Flexible Shaft
1� Use the Round “L” Tool to prevent the Flexible
Shaft Core from turning by inserting it into the
hole in the side of the Flexible Shaft Handle�
2� Once “L” tool is in place, remove
the Collet locking nut by turning it
counterclockwise with the Wrench�
3� Place the bit into the appropriate sized collet�
4� Place the collet into the end of
the Flexible Shaft Handle�
5� Place the Collet Locking Nut over the bit,
and tighten it by turning clockwise�
6� Tighten in place using the Wrench
and the Round “L” Tool�
Wrench
“L” Tool
Loosen
Tighten
Installing or Removing Collars
The Front Collar (3) is interchangeable
with the LED Collar (23)�
1� Remove the previous collar by
turning counterclockwise�
2� Install the LED Collar or standard
collar by turning clockwise�
Note: When installing or removing, use only
hand pressure and tighten firmly by hand�
Do not overtighten, as this may damage the part�