Product manual

Page 9For technical questions, please call 1-888-866-5797.Item 96464
SAFETYOPERATIONMAINTENANCE SETUP
Welding with Welding Rods
NOTE: When welding with welding rods, use
the correct welding rod for the material being
welded. If welding vinyl, use a vinyl welding
rod. If welding PVC, use a PVC welding rod.
CAUTION! Never place a welding
rod inside the Nozzle (6).
1. Material up to 1/2" thick can be welded.
As different types of plastic material
will melt at different temperatures, the
Potentiometer must be properly adjusted.
2. Hold the Welder with one hand. With the other
hand, hold the welding rod. Hold the welding rod
close to the Nozzle (about 1/4" to 3/8" away).
3. You are now ready to begin the welding operation.
4. When pausing between welds, and when
finished using, rest the Welder gently on
a metal surface to avoid impact or shock
to the inner components of the tool.
5. When finished using the Welder, set the
Potentiometer to “2”. Then disconnect the
Power Cord (1) from its electrical outlet.
6. IMPORTANT! Keep the air flowing for
several minutes to allow the Welder to
cool. Then close the air supply.
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Always store the tool in a clean, dry,
safe location out of reach of children
and other unauthorized people.
4. CAUTION! All maintenance, service, and repairs
not mentioned in this manual must only be
performed by a qualified service technician.
5. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.