Product manual

Page 4 For technical questions, please call 1-888-866-5797. Item 96464
SAFETY OPERATION MAINTENANCESETUP
Service
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Welder Safety Warnings
1. Do not use near flammable materials.
2. Do not touch barrel or tip when using. Do
not touch any metal parts on Welder
until they have completely cooled.
3. Do not place the Welder in a vise
to change heating elements.
4. Always use pliers to change the tip on the Welder.
5. Avoid electrical shock. Do not use in
a damp or wet environment.
6. Never rest Welder on flammable surface.
7. The recommended air flow for this Welder is
between 1.4 and 5.2 CFM. Failure to stay
within the recommended air flow will cause
overheating and possible damage to the Welder.
8. Compressed air only. Use clean, dry, regulated,
compressed air. Do not use bottled oxygen,
carbon dioxide, combustible gases, or any other
bottled gases as a power source for this tool.
9. This Welder features an air volume safety shut-
off which protects Welder from overheating in
event of air supply loss. Even so, never run
Welder for prolonged periods of time without air.
10. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
11. Avoid unintentional starting.
Prepare to begin work before turning on the tool.
12. Do not leave the tool unattended when it is plugged
into an electrical outlet. Turn off the tool, and
unplug it from its electrical outlet before leaving.
13. Use clamps (not included) or other practical ways
to secure and support the workpiece to a stable
platform. Holding the work by hand or against your
body is unstable and may lead to loss of control.
14. This product is not a toy.
Keep it out of reach of children.
15. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
In addition, people with pacemakers should:
• Avoid operating alone.
• Do not use with Trigger locked on.
• Properly maintain and inspect to avoid
electrical shock.
• Properly ground power cord. Ground Fault Circuit
Interrupter (GFCI) should also be implemented
– it prevents sustained electrical shock.
16. WARNING: The cord of this product contains
lead, a chemical known to the State of California
to cause cancer, and birth defects or other
reproductive harm. Wash hands after handling.
(California Health & Safety Code § 25249.5, et seq.)
17. WARNING: The brass components of this product
contain lead, a chemical known to the State
of California to cause cancer and birth defects
or other reproductive harm. (California Health
& Safety Code § 25249.5, et seq.)
18. The warnings, precautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur.
It must be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE INSTRUCTIONS.