Product manual

Page 3For technical questions, please call 1-800-444-3353.Item 60234
Setup
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Remove load from the jack before any procedure on this page.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 7.
Assembly
1. Connect a Support (22) to each corner of the
Saddle (21) using a Bolt (24) and Washer (23).
2. Use Bolt (25), Washer (26), and Nut (27)
to attach the Chain (28) to the hole on the
bracket on the Saddle, as shown.
Bolt (24)
Washer (23)
Support (22)
Saddle (21)
Bolt (25)
Nut (27)
Chain (28)
Washer (26)
Figure A: Assembly
Checking/Filling Hydraulic Fluid
IMPORTANT! Before first use:
1. Remove the Oil Fill Plug.
2. Check hydraulic oil level and fill to 1/4"
below the fill port as needed.
3. Replace the Oil Fill Plug.
4. Thoroughly test the Jack for proper operation.
If it does not work properly, bleed air from its
hydraulic system as described in Bleeding, below.
Release
Valve
Oil Fill
Plug
Handle
Figure B: Hydraulic Fluid Service Parts
Bleeding
1. Follow the Checking/Filling Hydraulic Fluid
instructions above.
2. Turn the Release Valve counterclockwise to open it.
3. Pump the Handle up and down quickly several
times to purge air from the system.
4. Check hydraulic oil level and fill to
1/4" below the fill port as needed.
5. Replace the Oil Fill Plug and close the
Release Valve by turning it clockwise.