Specifications Weight Capacity 800 lb. Maximum Height 22-1/2" Tilt 55º forward, 8º back, 30º side Minimum Height 8-1/2" WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Setup Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product. TO PREVENT SERIOUS INJURY: Remove load from the jack before any procedure on this page. Note: For additional information regarding the parts listed in the following pages, refer to Parts List and Diagram on page 7. Assembly 1. Connect a Support (41) to each corner of the Saddle (32) using a Bolt (39) and Washer (40).
Functions Support Saddle Chain tab Side Tilt Knob Forward Tilt Knob Handle Release Valve Page 4 For technical questions, please call 1-800-444-3353.
Operation Read ENTIRE IMPORTANT SAFETY INFORMATION section at beginning of this manual including all text under subheadings therein before set up or use of this product. Removing a Transmission 1. Before every use, check and/or fill Hydraulic Fluid. 2. Once the vehicle is raised and secured on a lift, clear the area underneath the vehicle of people and tools. 3. Remove the Chain and set aside. 4. Move the Transmission Jack underneath the transmission. 5. Close the Release Valve. 6.
Maintenance and Servicing Procedures not specifically explained in this manual must be performed only by a qualified technician. TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. 1. BEFORE EACH USE, inspect the general condition of the equipment. Check for: 4. Change the hydraulic oil at least once every three years: • loose hardware, a.
Parts List and Diagram Part 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Description Bolt M6x14 Caster Snap Ring Ø22 Flat Washer Ø6 Lock Washer Ø6 Nut M6 Inner Hex Bolt M8x16 Lock Washer Ø8 Big Flat Washer Ø8 Base Assembly Hydraulic Assembly Long Shaft Cotter Pin M6x45 Lifting Arm Assembly Long Connecting Rod Snap Ring Ø16 Connecting Shaft Shaft Sleeve Short Connecting Rod Forward Tilt Knob Bracket Qty 16 4 2 16 16 16 2 2 2 1 1 1 1 1 2 4 1 2 2 1 1 Part 22 23 24 25 26 27 28 29 30 31 32 33 34 35
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
