Product manual

SKU 94562 For technical questions, please call 1-800-444-3353 PAGE 5
Do not attempt to move a load while it is supported by the Long Ram Jack. 15.
The Jack must only be used in a static position for lifting and lowering loads.
Compressed air only. 16. Use clean, dry, regulated, compressed air between 110
and 120 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other
bottled gas as a power source for this product.
This Jack is intended for use on a shop crane (not included), properly at-17.
tached. The shop crane to which the Long Ram Jack will be installed must
be designed to use an 8 ton (16,000 pound) capacity Long Ram Jack.
The Long Ram Jack is designed for vertical, or near vertical, use only. 18. Do not
use in a horizontal or upside down position.
NEVER attempt to adjust the factory pre-set Safety Valve on the Long Ram 19.
Jack.
Not to be used for aircraft purposes.20.
WARNING! 21. The warnings and cautions discussed in this manual cannot cover all
possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
NOTE: 1. To attach the Long Ram Jack onto a shop crane you will need two 5/8”
diameter Pins of appropriate length and two R-Pins (neither included).
PIN
R-PIN
5/8” DIAMETER
FIGURE A
WARNING! The Pins must be rated to support at least 8 tons
(16,000 pounds) of pressure. (See Figure A.)