Product manual

Page 10SKU 95607
For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual.
WARNING! Make sure the Power Switch of the Lathe is in its “OFF” position and
that the Lathe is unplugged from its electrical outlet before making any adjustments
to the Lathe.
Mount the Lathe on a benchtop by first measuring and marking three hole centers.
See Figure 1.
Drill holes through the marked locations. Be sure there are no hidden wires.
Install the bolts and washers (not included) from under the benchtop and
into the holes in the bottom of the Lathe frame. Please note: To hold
the Lathe securely, the bolts must be a minimum of 1” into the frame.
5. The spring-loaded lock levers for the Tailstock
Spindle (N) and the Tool Rest (L) are made of
separate parts. If either lock lever has come
loose during shipping, they must be reassembled.
6. To reassemble a lock lever, the shoulder screw
passes through the spring and the handle lever and
then into the Tailstock Spindle and Tool Rest, as
shown in Figure 2.
1.
2.
3.
4.
Figure 1
Figure 2
Shoulder
Screw
Spring
Handle
Lever
REV 07l