Product manual

Page 23For technical questions, please call 1-800-444-3353.Item 61229
SAFETYOPERATIONNETWORK SETTINGS
Recording Parameters
Record > Rec Para
Figure X
1. Channel: Select Channel.
2. Record: Select Enable or Disable.
3. Pack Duration: Select continuous recording
time for each pack (recording segment).
4. PreRecord: Enable to start Motion Detection
recordings immediately before motion is detected.
Keep this enabled in most circumstances.
5. Copy: Copy parameters from one
Channel to other Channels.
a. Select Channel to copy from.
b. Select Channel to copy to or select ALL.
c. Click Copy, then click OK.
Changes will not be saved unless
you click Apply then OK!
Click Exit to return to System and
discard unsaved changes.
Video Stream
Record > MainStream
Set Resolution, Frames Per Second, Bitrate, Audio.
Figure Y
Resolution Quality
Fps
Range
Bitrate
Range
CIF - 352X240 Low 1 - 30 224 - 768
HDI - 704x240 Better 1 - 15 80 - 448
D1 - 704x480 Best 1- 7 80 - 448
Figure Z
1. Resolution: Select CIF, D1 or HD1.
2. Fps (Frames per second): Set as desired.
3. Bitrate (Kbps): Set as desired.
4. Audio - Check box to record audio if microphone
(sold separately) has been connected.
This is only available on Channel 1.
5. Copy: Copy parameters from one
Channel to other Channels.
a. Select Channel to copy from.
b. Select Channel to copy to or select ALL.
c. Click Copy, then click OK.
Changes will not be saved unless
you click Apply then OK!
Click Exit to return to System and
discard unsaved changes.