Product manual

ManualsBrandsHarbor Freight Tools ManualssecurityHarbor Freight Tools 8 Channel Surveillance DVR with 4 Cameras and Mobile Monitoring Capabilities

Page 14 For technical questions, please call 1-800-444-3353. Item 61229

SAFETY OPERATION NETWORKSETTINGS

Cameras - Before Mounting

1. Place Cameras in intended locations. When

planning mounting locations and angles:

a. Take into consideration the length of the Cables.

CAUTION! Route the Cables so as

to avoid a tripping hazard.

b. Choose locations high enough so that

they are out of reach of children, but still

cover the desired viewing areas.

c. Verify that installation surfaces have no hidden

utility lines before drilling or driving screws.

d. To avoid mounting the Cameras upside down,

make sure the Hood is above the Lens.

e. Make sure no strong light will shine

directly into Camera Lenses.

E. Mount Cameras

Using the Base as a template, mark locations

of mounting holes on mounting surface.

Note: Route Cable through slot on Base to keep Base

flush with mounting surface while marking holes.

Mounting

Holes

Cable

Slot

Base

Figure F

Solid Surface

1. Using a drill bit slightly smaller than the Screws,

drill pilot holes into the marked locations.

2. Position Camera so that mounting

holes align with pilot holes.

Note: Route Cable through slot on Base to

keep Base flush with mounting surface.

3. Drive Screws through mounting holes in

Base and into pilot holes until the Camera is

securely attached to the mounting surface.

Hollow Surface

1. Using a drill bit slightly smaller than the

Anchors, drill holes in the marked locations.

2. Tap Anchors into the holes until they are

almost flush with mounting surface.

3. Position Camera so that mounting

holes align with anchors.

Note: Route Cable through slot on Base to

keep Base flush with mounting surface.

4. Drive Screws through mounting holes in

Base and into anchors until the Camera is

securely attached to the mounting surface.

Camera Adjustment

1. Loosen Adjustment Wheel, rotate Camera as

needed, then tighten Adjustment Wheel.

2. Loosen Adjustment Screw, tilt Camera as

needed, then tighten Adjustment Screw.

Note: Only loosen Adjustment Screw

slightly, do not remove it.

Adjustment

Wheel

Adjustment

Screw

Figure G