Specifications Weight Capacity 750 lb. Assembled Dimensions 36" L x 31" W x 34" H Face Plate 9-7/8" W x 6" H x 3/8" thick Important Safety Information Assembly Precautions 1. Assemble only according to these instructions. Improper assembly can create hazards. 2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly. 3. Keep assembly area clean and well lit. 4. Keep bystanders out of the area during assembly. 5.
Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Post (5) Nut (15), Spring Washer (16), Washer (17) Rear Beam (22) Middle Beam (14) Middle Beam (14) Caster (18) Bolt (19) Spring Washer (21) Bolt (20) 2. Insert Middle Beam (14) into the 3. receiver at the base of the Post (5).
Pin (4) Handle Grip (3) Washer (7) Handle (2) Mounting Plate (8) Split Pin (1) Bolt (10) Mounting Arm (9) Post (5) Figure C: Attach Mounting Plate and Handle 4. Insert Mounting Plate (8) shaft into the top of the Post (5). 5. Slide Handle Grip (3) on to Handle (2). 6. Insert the Handle (2) through the Mounting Plate (8) shaft and secure with Split Pin (1). Page 4 Nut (6) Figure D: Install Mounting Arms and Lock Rotation 7.
Operating Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Mounting Engine TO PREVENT SERIOUS INJURY: Before attaching an engine to the stand, confirm that its weight does not exceed the Stand maximum capacity. 1. Remove the Pin (4) from the Post (5). 4. 2. Loosen bolts holding Mounting Arms (9) and align them with four mounting bolt locations on the engine. 5.
Maintenance and Servicing Procedures not specifically explained in this manual must be performed only by a qualified technician. TO PREVENT SERIOUS INJURY FROM STAND FAILURE: Do not use damaged equipment. Make sure the stand is stable. If any unsafe conditions are found, take it to a qualified technician for service or repair. 1. 2. BEFORE EACH USE, inspect the general condition of the Stand.
Parts List and Diagram Part Description 1 2 3 4 5 6 7 8 Split Pin Handle Handle Grip Pin Post Nut M12 Washer Ø12 Mounting Plate Qty 1 1 1 1 1 4 4 1 Part Description 9 10 11 12 13 14 15 16 Mounting Arm Bolt M12x45 Snap Ring Ø14 Washer Ø14 Rear Wheels Middle Beam Nut M8 Spring Washer Ø8 Qty 4 4 2 2 2 1 4 4 Part Description 17 18 19 20 21 22 Qty Washer Ø8 3" Caster Bolt M8x20 Bolt M12x80 Spring Washer Ø12 Rear Beam 4 1 4 1 1 1 3 2 7 8 4 6 1 9 10 5 11 12 13 22 14 15 16 17 21 20 13 12 11 1
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.
