Product manual

Page 10 For technical questions, please call 1-800-444-3353. Item 60608
SAFETY OPERATION MAINTENANCESETUP
Attaching Locking Knobs
1. Align the Right Guide Rail Stand (111)
as shown in Figure 6, right.
2. Remove the shipping screw and attach one Locking
Knob (75) through the slot in the Right Guide Rail
Stand (111) and into the threaded hole as shown.
Note: The Right Guide Rail Stand (111) is held in
place by the packaging during shipment. Always
tighten the T-Knob (107) to lock the Rail Stand prior to
performing maintenance or relocating the Tile Saw.
3. Repeat procedure for the Left Guide Rail
Stand (72) and the other Locking Knob (75).
4. Tighten Knobs securely.
Figure 6: Attaching Locking Knobs
Locking
Knob (75)
Right Guide
Rail Stand
(111)
Slot
T-Knob (107)
Wheel Assembly
1. Attach the Wheels (54) to Stand I (119) using
two Bolts (57), Spring Washers (2), and Flat
Washers (3) per wheel assembly. See Figures 7– 8.
Figure 7: Wheel Assembly Components
Wheel
Bracket
(55)
Wheel (54)
Bolt (57)
Spring Washer (2)
Flat Washer (3)
2. Insert Bolts and Washers from outside,
through the leg of the stand and into the
nut on the Wheel Bracket (55).
Wheel
Bracket
(55)
Wheel (54)
Bolt (57),
Spring Washer (2),
Flat Washer (3)
Stand I (119)
Figure 8: Wheel Assembly
3. Tighten all hardware securely.
4. To move the Tile Saw, engage the wheels by lifting
the saw stand using the handle on the end of the
saw opposite the wheels, as shown in figure 9.
Figure 9: Moving Tile Saw